Multicast Filtering
227
3
Displaying Interfaces Attached to a Multicast Router
The Multicast Forward All Page contains fields for attaching ports or LAGs to a
device that is attached to a neighboring Multicast router/switch. Once IGMP
Snooping is enabled, Multicast packets are forwarded to the appropriate port or
VLAN. Unless LAGs are defined, only a Multicast Forward All table displays.
The following table summarizes the Multicast settings which can be assigned to
ports in the Multicast Forward All Page:
• D — Attaches the port to the Multicast router or switch as a dynamic port.
• S — Attaches the port to the Multicast router or switch as a static port.
• F — Forbidden.
• N — The port is not attached to a Multicast router or switch.
Command Attributes
• VLAN ID — DIsplays the VLAN for which Multicast parameters are displayed.
• Ports — Ports that can be added to a Multicast service.
• LAGs — LAGs that can be added to a Multicast service.
Web – Click Layer 2, Multicast, Bridge Multicast, Multicast Forward All. Select the
required VLAN ID from the scroll-down list to display the associated multicast
routers.
1 0100.5e02.0203 static 1/e11, 1/
e12
19 0100.5e02.0208 static 1/e11-16
19 0100.5e02.0208 dynamic 1/e11-12
Forbidden ports for multicast addresses:
Vlan MAC Address Ports
---- ----------- ----------
1 0100.5e02.0203 1/e8
19 0100.5e02.0208 1/e8
To Next Page
Loading...
