Alcatel OmniStack LS 6248 - Figure 3-121. Cos to Queue Page; Mapping DSCP Values to Queues

Configuring Quality of Service
241
3
Figure 3-121. CoS to Queue Page
CLI – The following is an example of the CLI commands used to map CoS values to
forwarding queues:
Mapping DSCP Values to Queues
The DSCP Priority Page contains fields for classifying DSCP settings to traffic
queues.
Command Attributes
• DSCP In — Displays the incoming packet’s DSCP value.
• Queue — Defines the traffic forwarding queue to which the DSCP priority is
mapped. In a standalone device, four traffic priority queues are supported. In
stacked devices, three priority queues are supported.
Web – Click Policy, General QoS, Queue Mapping, DSCP Priority. DSCP Priority
define the fields, and click Apply.
Console(config)# wrr-queue cos-map 2 7
4-481