Command Line Interface
500
4
Related Commands
radius-server host
radius-server key
radius-server retransmit
radius-server source-ip
radius-server deadtime
show radius-servers
radius-server deadtime
The radius-server deadtime Global Configuration mode command improves
RADIUS response time when servers are unavailable. The command is used to
cause the unavailable servers to be skipped. To return to the default configuration,
use the
no form of this command.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
Parameters
• deadtime — Length of time in minutes during which a RADIUS server is
skipped over by transaction requests. (Range: 0 - 2000)
Default Setting
The deadtime setting is 0.
Command Mode
Global Configuration mode
Command Usage
There are no user guidelines for this command.
Example
The following example sets the deadtime to 10 minutes.
Related Commands
radius-server host
radius-server key
radius-server retransmit
radius-server source-ip
radius-server timeout
show radius-servers
Console(config)# radius-server deadtime 10
To Next Page
Loading...
