Command Line Interface
438
4
Command Usage
There are no user guidelines for this command.
Example
The following example configures the device as a virtual terminal for remote console
access.
Related Commands
show line
speed
The speed Line Configuration mode command sets the line baud rate. To return to
the default configuration, use the
no form of the command.
Syntax
speed bps
no speed
Parameters
• bps—Baud rate in bits per second (bps). Possible values are 2400, 9600,
19200, 38400, 57600 and 115200.
Default Setting
The default speed is 9600 bps.
Command Mode
Line Configuration (console) mode
Command Usage
This command is available only on the line console.
The configured speed is applied when Autobaud is disabled. This
configuration applies only to the current session.
Examples
The following example configures the line baud rate to 115200.
Related Commands
show line
Console(config)# line telnet
Console(config-line)#
Console(config)#
line console
Console(config-line)# speed 115200
To Next Page
Loading...
