Command Line Interface
542
4
spanning-tree cost
spanning-tree port-priority
spanning-tree portfast
spanning-tree link-type
show spanning-tree
spanning-tree hello-time
The spanning-tree hello-time Global Configuration mode command configures the
spanning tree bridge hello time, which is how often the device broadcasts hello
messages to other devices.To return to the default configuration, use the
no form of
this command.
Syntax
s
panning-tree hello-time seconds
no spanning-tree hello-time
Parameters
• seconds — Time in seconds. (Range: 1 - 10)
Default Setting
The default hello time for IEEE Spanning Tree Protocol (STP) is 2 seconds.
Command Modes
Global Configuration mode
Command Usage
When configuring the hello time, the following relationship should be kept:
Max-Age >= 2*(Hello-Time + 1)
Example
The following example configures spanning tree bridge hello time to 5 seconds.
Related Commands
spanning-tree forward-time
spanning-tree max-age
spanning-tree priority
spanning-tree disable
spanning-tree cost
spanning-tree port-priority
spanning-tree portfast
Console(config)# spanning-tree hello-time 5
To Next Page
Loading...
