Command Line Interface
464
4
Related Commands
show power inline
show power inline
The show power inline User EXEC mode command displays the information about
inline power.
Syntax
show power inline [ethernet interface]
Parameters
• interface — Valid Ethernet port. (Full syntax: unit/port)
Default Setting
This command has no default configuration.
Command Mode
User EXEC mode
Command Usage
There are no user guidelines for this command.
Example
The following example displays information about inline power.
Console# show power inline
Power: On
Nominal Power: 150 Watt
Consumed Power: 120 Watts (80%)
Usage Threshold: 95%
Traps: Enabled
Port Powered Device State Priority Status Classification [w]
---- -------------
---
----- -------- ------ -----------------
1/e1 IP Phone Model
A
Auto High On 0.44 - 12.95
2/e1 Wireless AP
Model
Auto Low On 0.44 - 3.84
3/e1 Auto Low Off N/A
Console
# show power inline ethernet 1/e1
To Next Page
Loading...
