Alcatel OmniStack LS 6248 - Show Fiber-Ports Optical-Transceiver

PHY Diagnostics Commands
453
4
Parameters
• interface — A valid Ethernet port. (Full syntax: unit/port)
Default Setting
This command has no default configuration.
Command Mode
User EXEC mode
Command Usage
The port must be active and working in 100M or 1000M mode.
Example
The following example displays the estimated copper cable length attached to all
ports.
Related Commands
test copper-port tdr
show copper-ports tdr
show fiber-ports optical-transceiver
The show fiber-ports optical-transceiver Privileged EXEC command displays the
optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [interface] [detailed]
Parameters
• interface — A valid Ethernet port. (Full syntax: unit/port)
•
detailed — Detailed diagnostics.
Default Setting
This command has no default configuration.
Command Mode
Privileged EXEC mode
Console> show copper-ports cable-length
Port Length [meters]
---- ---------------------
1/e1 < 50
1/e2 Copper not active
1/e3 110-140
1/g1 Fiber