Command Line Interface
528
4
snmp-server v3-host
The snmp-server v3-host Global Configuration mode command specifies the
recipient of Simple Network Management Protocol Version 3 notifications. To
remove the specified host, use the
no form of this command.
Syntax
snmp-server v3-host {ip-address | hostname} username [traps | informs]
{noauth | auth | priv} [udp-port
port] [filter filtername] [timeout seconds]
[retries
retries]
no snmp-server v3-host {
ip-address | hostname} username [traps | informs]
Parameters
• ip-address — Specifies the IP address of the host (targeted recipient).
• hostname — Specifies the name of the host. (Range:1-158 characters)
• username — Specifies the name of the user to use to generate the
notification. (Range: 1-25)
•
traps — Indicates that SNMP traps are sent to this host.
•
informs — Indicates that SNMP informs are sent to this host.
•
noauth — Indicates no authentication of a packet.
•
auth — Indicates authentication of a packet without encrypting it.
•
priv — Indicates authentication of a packet with encryption.
• port — Specifies the UDP port of the host to use. If unspecified, the default
UDP port number is 162. (Range: 1-65535)
• filtername — Specifies a string that defines the filter for this host. If
unspecified, nothing is filtered. (Range: 1-30 characters)
• seconds — Specifies the number of seconds to wait for an acknowledgment
before resending informs. If unspecified, the default timeout period is 15
seconds. (Range: 1-300)
• retries — Specifies the maximum number of times to resend an inform
request. If unspecified, the default maximum number of retries is 3.
(Range: 1-255)
Default Setting
This command has no default configuration.
Command Mode
Global Configuration mode
Command Usage
A user and notification view are not automatically created. Use the
snmp-server user, snmp-server group and snmp-server view Global
Configuration mode commands to generate a user, group and notify group,
respectively.
To Next Page
Loading...
