Configuring the Switch
236
3
• Default CoS — Determines the default CoS value for incoming packets for which
a VLAN tag is not defined. The possible field values are 0-7. The default CoS is 0.
• Restore Defaults — Restores the factory QoS default settings to the selected port.
• Checked — Restores the factory QoS default settings to the ports.
• Unchecked— Maintains the current QoS settings.
Web – Click Policy, General QoS, General, CoS Mode, define the fields, and click
Apply.
Figure 3-117. CoS Mode Page
CLI – The following is an example of the CLI commands used to enable QoS:
Defining Global Queue Settings
The Queue Priority Page contains fields for defining the QoS queue forwarding
types. The queue settings are set system wide.
Command Attributes
• Queue — Displays the queue for which the queue settings are displayed. The
possible range is 1-4.
• Strict Priority — Indicates that traffic scheduling for the system is based strictly on
the queue priority.
• WRR — Indicates that traffic scheduling for the selected queue is based strictly on
the WRR. If WRR is selected, the predetermined weights 8, 2, 4, and 1 are
assigned to queues 4,3,2 and 1.
Console(config)# qos
4-468
To Next Page
Loading...
