EasyManua.ls Logo

allen AR21 - Page 28

Default Icon
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ø If operator must leave operator’s station (standing between handlebars either on operator’s
platform or standing on the ground with the platform in the “UP” position) the operator must:
a) Stop equipment. Do not block access to fire isles, stairways, fire equipment.
b) Set and lock parking brake.
c) Shut off engine by turning engine ignition switch off or depressing
EMERGENCY stop button on dash. Note: Some older Honda Engines required the
“Emergency Stop Switch” to be “Pushed Down and Held” to stop the engine.
Identify which type of Honda Engine you have and the “Emergency Stop” switch
operation required to stop the engine.
Ø Wear appropriate clothing/safety equipment for the construction job site including but not lim-
ited to safety glasses, clean gloves, safety toed work boots, hard hat, etc. Do not operate this
equipment with oily gloves or controls.
Ø This equipment is not intended to tow other items or equipment. NO TOWING.
Ø Keep yourself and others away from pinch points on dumping mechanism.
Ø Refer to LIFTING/LOADING/TIE-DOWN INSTRUCTIONS section of this manual. Note the
two (2) ways a buggy may be lifted and the appropriate lifting points for each method. Note the
specific load ratings for chains, straps, forklifts. and cranes.
Ø Avoid all operating conditions where any personnel, including the operator, could become
trapped or pinched between the buggy and another obstacle or where a lifted buggy may fall
during loading.
Refer to the Lifting/Loading/Tie Down Instructions in this manual. Note the proper method for
loading a buggy on a trailer and the limits for loading ramp angle and trailer towing vehicle capac-
ity. Refer to this same section for specific ratings for chains, straps and binders used to tie down
a buggy.
DO NOT OPERATE THIS BUGGY IN AREAS WITH FLAMMABLE
OR EXPLOSIVE ATMOSPHERES. REFER TO CODE OF FEDERAL
REGULATIONS OSHA 29 CFR PART 1910.178 TO DETERMINE PERMISSIBLE AREAS
WHERE THESE BUGGIES MAY BE OPERATED.
Ø Do not mount/dismount a moving buggy.
Ø If operator chooses to walk behind the buggy during operation, the operator’s platform must
be lifted, pulled back & locked in the UP position before using the buggy. Reduce travel speed
to a MAXIMUM of 3mph(comfortable walking speed) when using buggy in walk behind fashion.
1.4 - Operating Safety, continued
SECTION 1
SAFETY
055838 Page 28

Table of Contents

Related product manuals