In all cases, upon release of the speed control lever, the speed control
linkage should operate smoothly and freely and stop machine travel within 6 - 8’ in both
forward and reverse. If the speed control linkage does not operate smoothly and freely
and/or does
not automatically stop machine travel upon release of the speed control lever, then remove
machine from service until repairs have been made.
LIFTING / LOADING AND TIE DOWN PROCEDURES
LIFTING / LOADING AND THE TIE-DOWN PROCEDURES WHEN LIFTING,
LOADING AND/OR TYING DOWN A BUGGY AVOID ALL OPERATING CONDITIONS WHERE
PERSONNEL MAY BECOME TRAPPED OR PINCHED BETWEEN THE BUGGY AND SOME
OTHER OBSTACLE.
FOR LIFTING AND TYING DOWN ONLY USE OSHA COMPLIANT CHAINS OR STRAPS WITH
A MINIMUM WORKING LOAD LIMIT OF 2,500 LB. EACH. LIFT OR LOAD THE BUGGY ONLY
WHEN THE ENGINE IS OFF AND THE BUCKET IS EMPTY. FOR 13 HP HONDA ENGINE
ONLY, WHEN TRANSPORTING THE BUGGY ON A TRAILER SHUT OFF THE FUEL AT THE
CARBURETOR TO PREVENT FUEL LEAKING INTO THE CRANKCASE.
WHEN EMPTY, THE BUGGY CAN WEIGH UP TO 1,800 LB. TO LOAD, LIFT OR TIE DOWN
USE ONLY EQUIPMENT DESIGNED TO HANDLE THIS WEIGHT. DO NOT ATTEMPT TO
MANUALLY PUSH OR PULL A BUGGY. FAILURE TO LIFT, LOAD OR TIE DOWN WITH THE
PROPER EQUIPMENT COULD RESULT IN SERIOUS INJURY OR DEATH.
3.8 - Maintenance, continued
www.facebook.com/AllenEngineering
@alleneng
www.youtube.com/AllenMachinery
LIKE US!!!
FOLLOW US!!!
WATCH US!!!
VISIT US!!! www.alleneng.com
SECTION 3
SERVICE
055838 Page 65
To Next Page
Loading...
