Chapter 7: SNMP Commands
80
Mode
Global Configuration mode
Description
Use this command to specify the IP addresses of SNMP network devices
to receive traps from the switch. The community and user names must
already exist. For instructions, refer to “SNMP-SERVER COMMUNITY” on
page 75.
Example
This example assigns the IPv4 address 149.44.12.44 of a trap receiver to
community string Bldg2a and user Sam. The traps are sent in the
SNMPv2c format:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# snmp-server host 149.44.12.44
version v2c Bldg2a/Sam
To Next Page
Loading...
