Allied Vision Alvium Series - Mounting Alvium Frame

264Alvium USB Cameras User Guide V4.6.1
Installing the camera
When you design Alvium Frame cameras into your system, observe values for:
• Flange focal distance, optical: 3.576 mm
• Maximum protrusion of 1.5 mm into the frame measured from the front
area (2).
Mounting Alvium Frame
Especially for dynamic applications with high acceleration, mount the camera using
all 4 mounting threads.
The maximum torque value applies only if the entire thread engagement is
used. For other values, see Adapting maximum torque values. For technical
drawings, with further values and tolerances, and references for alignment, see
Alvium Frame: Technical drawings on page 227.
As shown in Figure 90, mount the camera to the base using suitable M2 screws for
the 4 mounting threads: At 0.4 Nm maximum torque for a thread engagement (C)
of 3.6 mm between screws and mounting threads.
Dimensions and accuracy
For the dimensions and accuracy of the alignment areas and the alignment holes,
see Alvium Flex: Technical drawings on page 222.
For the accuracy of the sensor position, see Housed standard and Flex cameras:
Sensor shift and rotation on page 232 and Housed Alvium USB cameras: Sensor tilt
on page 233.
Figure 90: Mounting threads Alvium Frame
24.5
c
14.8
14.8
10.8
26
±0.1
c
c
c
ĞƚĂŝůĐDϮљϯϲљϰϭ
сDϮсϬсϯϲсϰϭ
D
B
C
A