312Alvium USB Cameras User Guide V4.6.1
Performance and troubleshooting
Reactivating operational mode
1. In the Device Manager, click Enable Device for the Allied Vision USB3 Vision
Device:
2. Open Vimba X Viewer.
The camera boots up. This may take about 2 seconds.
Power consumption issues
The power consumption of cameras is caused by such as the image sensor and
enabled features. The total power for the host system also includes the USB cable
loss. Unfavorable setups can prevent your system from working. What can you do?
Ensure sufficient power supply
Your host system must provide sufficient voltage and current at the USB
downstream connector on the host system for proper camera operation. If this is
not the case, we recommend you to power cameras by an external power supply,
using the I/O connector (see Camera interfaces on page 275 for details).
Figure 124: Enabling the Alvium camera in the Device Manager
To Next Page
Loading...
