277Alvium USB Cameras User Guide V4.6.1
Camera interfaces
I/O connector pin assignment
I/O connector details
JST BM07B-SRSS-TBT connector set consists of:
• Camera connector: JST BM07B-SRSS-TBT
• Cable housing: JST SHR-07V-S
• Cable, crimp contacts: JST SSH-003T-P0.2-H
See www.jst.de for details.
I/O cables and electromagnetic interference (EMI)
Consider for I/O cables by Allied Vision:
• 12319 JST I/O cables without screw lock have no shielding and are designed to
be used with bare board or open housing Alvium cameras.
• For applications without an additional EMC housing, use shielded cables, such
as 12322 JST I/O cables with screw lock.
NOTICE
Damage by reverse polarity
If Alvium USB cameras are externally powered with reverse polarity, the cameras
can be damaged.
Power Alvium USB cameras according to the specifications described in this
section.
NOTICE
Damage by serial communication voltage levels
If you are using serial communication (UART, similar to RS232), keep voltage levels
in the range defined in Table 143 on page 278. Typical RS232 voltage levels (such as
±10 VDC) are not supported without external circuitry.
To Next Page
Loading...
