Allied Vision Alvium Series - For customers in the USA; United States of America: Supplier Declaration of Conformity; Party issuing Suppliers Declaration of Conformity; Responsible Party - U.S. Contact Information

51Alvium USB Cameras User Guide V4.6.1
Compliance, safety, and intended use
For customers in the USA
Closed housing cameras only: FCC Class B digital device
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
United States of America: Supplier
Declaration of Conformity
Alvium USB cameras comply with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
Party issuing Supplier's Declaration of Conformity
Allied Vision Technologies GmbH
Taschenweg 2a
07646 Stadtroda
Germany
T// +49 (36428) 677-106
quality@alliedvision.com
Responsible Party - U.S. Contact Information
Allied Vision Technologies, Inc.
102 Pickering Way – Suite 502
Exton, PA 19341
USA
T// +1 978 225 2030
Note: changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.