96Alvium USB Cameras User Guide V4.6.1
Specifications
ROI frame rates
Values were measured as defined in Specified values on page 67.
To reach the maximum frame rate available for this setup, the bandwidth for image
traffic is 200 MByte/s. Increasing the
DeviceLinkThroughputLimit value does
not increase frame rates.
Image
format
Width
[pixels]
Height
[pixels]
ROI
area
[MP]
Frame rate [fps]
1
450 MByte/s 375 MByte/s 200 MByte/s
Full
resolution
1296 1032 1.337 130.9/121.3/69.8 130.9/70.8/69.8
SXGA 1280 1024 1.311 131.8/122.2/70.3 131.8/72.4/70.3
HD 720 1280 720 0.922 183.3/169.8/97.8 183.3/100.8/97.8
XGA 1024 768 0.786 173.1/160.5/92.4 173.1/118.7/92.4
SVGA 800 600 0.48 218.3/202.1/116.4 218.3/190.5/116.4
VGA 640 480 0.307 267.9/248.3/143.0 267.9/248.3/143.0
HVGA 480 320 0.154 384.9/356.4/205.2
QVGA 320 240 0.077 494.1/457.2/262.7
HQVGA 240 160 0.038 683.2/634.4/365.0
QQVGA 160 120 0.019 849.9/789.2/454.6
Max. × half 1296 516 0.669 246.6/228.2/131.8
Max. × min. 1296 8 0.01 2131.1/1921.6/1186.2
Min. × max. 8 1032 0.008 132.5/123.0/70.4
Min. × min. 8 8 64 P 2644.2/2455.3/1405.9
1
Mono8 at SensorBitDepth = 8-Bit
(2)
/ Mono10 at SensorBitDepth = 10-Bit /
Mono12 or at SensorBitDepth = 12-Bit
2
The SensorBitDepth value must be set separately from PixelFormat.
See
Sensor ADC readout modes for maximum frame rates on page 68 for details.
Table 31: Alvium 1800 U-130 VSWIR ROI frame rates
To Next Page
Loading...
