Amano MX-300 - Page 17

11
When an Overtime Beginning Time is configured, the time
from the corresponding start time to a minute prior to Day
Change Time is treated as an Overtime Zone.
If the Overtime Beginning Time is set to a time other than the
Shift End Time, then the time between the two is treated as
break time.
When a Midnight Shift Beginning and End time is
configured, the corresponding time zone is treated as a
Midnight Time Zone and is the corresponding hours
worked during that time is calculated separately from
overtime hours in the monthly totals. (The daily totals
for both overtime and midnight hours are printed as one
total.)
When you finish configuring the Midnight Shift Time Zone
the programming card is ejected.
Next, turn the card over the back side to insert
PROGRAMMING CARD FOR REGULAR EMPLOYEES #4.
You can configure up to four scheduled ("fixed") breaks
a day for regular employees. The time zone for a given
break is determined by the Fixed Break Beginning and
End Time.
* You may not configure breaks so that they run back to back
or overlap each other!
NG NG
* Also, you may not configure breaks so that they overlap
Shift Beginning and End Times.
 The following setting is a detail example of page 22's
"How to Change the Calculation Mode" when selecting the
option for hourly workers. The settings are only valid for
the type of hourly worker selected.
Overtime Beginning Time
Not configured
Factory Setting
Configure
Don't
configure
"How to Adjust
the Overtime
Beginning Time"
Go to Page 30
Example: Overtime Beginning Time: 17:30
Regular Hours Time Zone
5678910111213 19202114 15 16 17 2 3 4
Overtime Zone
22 23 24 118
Day Change Time
Overtime Beginning
Time
Break Time
Shift
Beginning
Time
Shift End
Time
Midnight Time Zone
Not configured
Factory Setting
Configure
"How to Adjust
the Midnight Shift
Time Zone"
Go to Page 31
Example: Midnight Shift Time Zone: 22:00 to 4:00
Midnight Shift Time Zone
Overtime Zone
Day Change Time
419 12321 22 23 2417 18 2013 14 15 169 1011125678
Regular Hours Time Zone
Overtime Zone
Break Time
Overtime
Beginning Time
Shift
Beginning
Time
Shift End
Time
Midnight Shift
Beginning Time
Midnight Shift
End Time
Breaks for Re
g
ular Em
p
lo
y
ees
Configure
"How to Configure
Breaks for Regular
Employees"
Go to Page 32
#1 Fixed
Break
#2 Fixed
Break
#1
Fi
xe
d
Break
#2
Fi
xe
d
Brea
k
Press Next
(button h)
Press Next
(button h)
Hourly Worker with Fixed Shift Ö Page 12 Hourly Worker with Open Shift Ö Page 14
Not configured
Factory Setting
PROGRAMMING CARD FOR
REGULAR EMPLOYEES #3 is
ejected.
Insert PROGRAMMING CARD
FOR REGULAR EMPLOYEES #4
PROGRAMMING CARD FOR REGULAR
EMPLOYEES #4 is ejected.
Day Change Time
minus 1 minute
Day Change Time minus
1 minute
Don't
configure
Don't
configure
Press Next
(button h)
four times
HOURLY WORKERS
WITH FIXED SHIFT
HOURLY WORKERS
WITH OPEN SHIFT
Go to "How to Change the Calculation
Mode" Ö Page 22