Ametek 2003RP User Manual

10.10.1 *CLS
This command clears the following registers (see chapter 12 for descriptions of all status
registers):
Standard Event Status
Status Byte
Error Queue
Command Syntax *CLS
Parameters None
10.10.2 *ESE
This command programs the Standard Event Status Enable register bits. The programming
determines which events of the Standard Event Status Event register (see *ESR?) are
allowed to set the ESB (Event Summary Bit) of the Status Byte register. A "1" in the bit
position enables the corresponding event. All of the enabled events of the Standard Event
Status Enable Register are logically OR-ed to cause the Event Summary Bit (ESB) of the
Status Byte Register to be set. See Section 16 for descriptions of the Standard Event Status
registers.
The query reads the Standard Event Status Enable register.
Table 10-2: Bit Configuration of Standard Event Status Enable Register
Bit Position
7
6
5
4
3
2
1
0
Bit Name
PON
not used
CME
EXE
DDE
QYE
not used
not used
Bit Weight
128
32
16
8
4
CME
Command error
DDE
Device-dependent error
EXE
Execution error
QYE
Query error
PON
Power-on
Command Syntax *ESE <NRf>
Parameters 0 - 255
Power-On Value 128
Example *ESE 129
Query Syntax *ESE?
Returned Parameters <NR1>(Register value)
Related Commands *ESR? *STB?

Ametek 2003RP Specifications

General

Brand	Ametek
Model	2003RP
Category	Power Supply
Language	English