Ametek 2003RP - Table 10-3: Bit Configuration of Standard Event Status Register

10.10.3 *ESR?
This query reads the Standard Event Status register. Reading the register clears it. The bit
configuration of this register is the same as the Standard Event Status Enable register (see
*ESE).
Query Syntax *ESR?
Parameters None
Returned Parameters <NR1>(Register value)
Related Commands *CLS *ESE *ESE?
If the *ESR? returns the value of the status bits in the ESR register. Refer to Table 10-3 for
the status bits and their meaning.
Table 10-3: Bit Configuration of Standard Event Status Register
Bit Position
7
6
5
4
3
2
1
0
Bit Name
PON
not used
CME
EXE
DDE
QYE
not used
not used
Bit Weight
128
32
16
8
4
CME
Command error
DDE
Device-dependent error
EXE
Execution error
QYE
Query error
PON
Power-on