Appendix E, ALPHABETICAL LISTING OF COMMANDS
E-10
Parameter n
3
is used to set the addition/subtraction operator in the numerator
according to the following table:-
n
3
Operator
0 Subtraction
1 Addition
The parameters n
2
, n
4
, n
5
and n
6
specify the variables A, B, C and D respectively
according to the following table:
n Variable Range
0 X or X1 ±30000
1 Y or Y1 ±30000
2 MAG or MAG1 0 to 30000
3 PHA or PHA1 ±18000
4 ADC1 ±10000
5 ADC2 ±10000
6 ADC3 ±10000
7 ADC4 ±10000
8 C1 0 to 100000
9 C2 0 to 100000
10 0 zero
11 1 unity
12 FRQ 0 to 2000000000 (i.e. reference frequency in mHz)*
13 OSC 0 to 2000000000 (i.e. oscillator frequency in mHz)*
Dual modes only:-
14 X2 ±30000
15 Y2 ±30000
16 MAG2 0 to 30000
17 PHA2 ±18000
*Parameter n
5
is the only one that can be set to values of 12 or 13.
DEMOD2SRC [n] Second stage demodulator signal source
In the dual reference mode, the value of n sets the source of the signal for the second
stage demodulators according to the following table:
n Signal source
0 Main signal channel ADC (i.e. both demodulators are fed the same signal)
1 ADC1 - rear panel auxiliary ADC input
2 Demodulator 1 X channel output - this is the Tandem demodulation mode
ENBW[.] Equivalent noise bandwidth
In fixed point mode, reports the equivalent noise bandwidth of the output low-pass
filters at the current time constant setting in microhertz.
In floating point mode, reports the equivalent noise bandwidth of the output low-pass
filters at the current time constant setting in hertz.
EQU n Output result of equation #1 or equation #2
The value returned is the output of the user equation #1 (n = 1) or equation #2 (n =
2), where the equations are defined using the Output equations control panel (see
section 5.3.27). The possible range is ±2,147,483,647 (signed 32-bit integer).
To Next Page
Loading...