TABLE OF CONTENTS
v
GENERAL SAFETY PRECAUTIONS
The equipment described in this manual has been designed in accordance with EN61010 "Safety
requirements for electrical equipment for measurement, control and laboratory use", and has been
supplied in a safe condition. To avoid injury to an operator or service technician the safety precautions
given below, and throughout the manual, must be strictly adhered to, whenever the equipment is
operated, serviced or repaired. For specific safety details, please refer to the relevant sections within
the manual.
The equipment is intended solely for electronic measurement and should be used for no other purpose.
SIGNAL RECOVERY accepts no responsibility for accidents or damage resulting from any failure to
comply with these precautions.
Grounding
To minimize the hazard of electrical shock, it is essential that the equipment be connected to a
protective ground through the AC supply cable. The continuity of the ground connection should be
checked periodically.
AC Supply Voltage
Never operate the equipment from a line voltage or frequency in excess of that specified. Otherwise,
the insulation of internal components may break down and cause excessive leakage currents.
Fuses
Before switching on the equipment check that the fuses accessible from the exterior of the equipment
are of the correct rating. The rating of the AC line fuse must be in accordance with the voltage of the
AC supply.
Should any fuse continually blow, do not insert a fuse of a higher rating. Switch the equipment off,
clearly label it "unserviceable" and inform a service technician.
Explosive Atmospheres
This equipment must NEVER BE OPERATED in a potentially explosive atmosphere. The equipment is
NOT designed for use in these conditions and could possibly cause an explosion.
Safety Symbols
For the guidance and protection of the user, the following safety symbols may appear on the
equipment, together with details of the hazard where appropriate:
General safety hazard. Refer to the operating manual for detailed instructions.
Electrical safety hazard. This symbol may appear alongside the general safety
hazard symbol, together with a voltage.
Notes and Cautions
For the guidance and protection of the user, Notes and Cautions appear throughout the manual. The
significance of these is as follows:
NOTES highlight important information for the reader’s special attention.
CAUTIONS guide the reader in avoiding damage to the equipment.
To Next Page
Loading...