INDEX
INDEX-4
PHA[.] command 6-16, E-18
PHASEPOL [n] command 6-16, E-18
PORTDIR [n] command 6-23, E-18
Power input connector 4-3
Power switch 4-3
Power-up defaults 3-16
PS0110 power supply 2-1
Rack mounting 2-1
Ratio output 5-34
READBYTE command 6-24, E-19
Rear Panel
ADCs 5-36
Bind 5-39
DACs 5-33
Digital port 5-39
DIP switches 5-39
Expand 5-38
layout 4-3
Overview 5-32
Ref Mon 5-38
RS232 5-37
USB Status 5-40
REF IN connector 4-1
Reference 1
+90 Deg control 5-20
Auto-Phase 5-20
Frequency display 5-20
Harmonic control 5-20
Phase control 5-20
Source control 5-18
Reference 2
+90 Deg control 5-23
Auto-Phase 5-23
Frequency display 5-23
Harmonic control 5-23
Phase control 5-23
Source control 5-23
Reference channel inputs 3-7
Reference mode
external 3-2, 3-8
internal 3-2, 3-8
Reference phase shifter 3-8
REFMODE [n] command 6-11, E-19
REFMON [n] command 6-12, E-19
REFN [n] command 6-12, E-19
REFP[.] [n] command 6-12, E-19
RS [n
1
[n
2
]] command 6-31, E-19
RS232 interface
baud rate control 5-37
choice of baud rate 6-2
choice of number of data bits 6-2
choice of parity check option 6-2
connector 4-3
delimiter control 5-38
echo on control 5-38
general features 6-1
handshaking and echoes 6-3
N (overload) command 6-4
number of data bits control 5-37
parity control 5-37
prompt on control 5-38
prompts 6-4
ST (status) command 6-4
terminators 6-3
RS232 Operation 6-1
RT[.] command 6-17, E-20
SEN [n] command 6-10, E-20
SEN. command 6-10, E-20
SIG MON connector 4-4
Signal channel inputs 3-3
Signal phase 3-11
Single harmonic mode
described 3-1
Single reference mode
described 3-1, 5-13
SLOPE [n] command 6-15, E-21
SNMASK [n1 n2 n3 n4] command 6-33, E-21
Specifications
detailed listing of A-1
for analog outputs A-4
for auxiliary inputs A-4
for computer interfaces A-4
for data storage buffer A-4
for demodulators and output processing A-3
for internal oscillator A-3
for measurement modes A-1
for reference channel A-2
for reference input A-2
for signal channel A-1
weight and dimensions A-5
SRATE[.] [n] command 6-20, E-21
ST command 6-32, E-21
Status
Dynamic reserve 5-26
Input limit 5-26
Overload byte 5-26
Status byte 5-26
STATUS indicator 4-1
STR [n] command 6-26, E-22
SWEEP [n] command 6-20, E-22
SYNC [n] command 6-14, E-23
TADC [n] command 6-24, E-23
To Next Page
Loading...