Dansensor® MAP Mix Provectus EN User Guide 51
P/N 300862-K
11/2019
General setup
Selecting General setup from the Main menu will display a menu with available setup
parameters.
“Supervisor” access level is required for this menu, as the parameters in this menu control the
basic functionality of the device.
The General setup menu holds the following items:
Mixer configuration Opens the Mixer configuration screen
See "Mixer configuration" on page 52 for details.
Network setup Opens the Network setup screen
See "Network setup" on page 54 for details.
Data log setup Opens the Data log setup screen
See "Data log setup" on page 54 for details.
COM2 protocol PBI For control of a slave mixer
Defalt setting at start-up. When Termial
Server
has been selected, device will return to PBI
protocol when switched Off and On.
Terminal Server For configuration via terminal server.
Backlight Adjust display background light (1-10)
Contrast Adjust display contrast (1-10)
Brightness Adjust display brightness (1-10)
The “Backlight", "Contrast" and "Brightness" items are all
related to the display readability. Selecting each setting brings
up a new window where value can be set from 1 to 10.
Setting impact is seen while adjusting.
Formats/Units/Time Opens the Formats/Units/Time screen
See "Formats/Units/Time" on page 59 for details.
Reset gas consumption Resets the gas consumption counters in the “Gas
consumption since....” section in “Diagnostics”.
Supervisor PIN code setup Setting up the four-digit PIN code required for changing from
User access level to Supervisor access level.
(See "Access level" on page 60 for details).
General setup
Mixer configuration
Network setup
Data log setup
COM2 protocol
Backlight
Contrast
PBI
8
9
To Next Page
Loading...
