Ametek mocon Dansensor MAP Mix ProVectus - Page 57

Dansensor® MAP Mix Provectus EN User Guide 55
P/N 300862-K
11/2019
Network logging Select whether or not network logging is required.
No No network logging
Ye s Network logging enabled
(Below parameters only appears when “Network Logging” is set to
“Yes”).

Network logging Select required data logging output format:
mode Compatible (Default)
Data format as used on devices
with firmware versions < 4.2.0.
See table on page 56.
Advanced New data format with more
information and many new
values.
See table on page 57.
Server IP Set up an IP-address to be used for collecting
log data for each measurement via LAN.
This requires for setting up of a Server Port
number as well.
Server Port See above.
Acknowledge Acknowledge byte can be used if a
“handshake” is required for each measurement
between device and server, each to be set up
to same value.
Disable network Select whether or not network errors should
errors be disabled.
Allows for continued operation while LAN is
not connected.