Ampcontrol IPD - Table of Contents

Ampcontrol Pty Ltd – ABN 28 000 915 542
IPD USER MANUAL
IPDB014 Version 14 – SEP/2020
Uncontrolled Copy - Refer to Ampcontrol Website for Latest Version
Page 4 of 96
APPROVED FOR EXTERNAL DISTRIBUTION
– PROPERTY OF AMPCONTROL PTY LTD
– NOT TO BE REPRODUCED IN PART
TABLE OF CONTENTS
1 VERSION HISTORY ......................................................................................... 7
1.1 IPD Hardware Version History ................................................................... 7
1.2 IPD Software Version History ..................................................................... 7
1.3 RTU-D Version History .............................................................................. 7
2 SAFETY AND OTHER WARNINGS .................................................................. 8
2.1 Safe Use of Equipment .............................................................................. 8
2.2 Operational Restrictions and Limits ............................................................ 9
3 RECEIVING AND STORAGE .......................................................................... 11
3.1 Receiving ................................................................................................. 11
3.2 Inspection ................................................................................................ 11
3.3 Storage after Delivery .............................................................................. 11
3.4 Unpacking of Equipment .......................................................................... 11
4 PRODUCT OVERVIEW .................................................................................. 12
4.1 IPD Integrated Protection Relay ............................................................... 12
4.2 Accessories ............................................................................................. 15
5 INSTALLATION ............................................................................................... 19
5.1 General Warnings .................................................................................... 19
5.2 Mandatory Installation Practices .............................................................. 20
5.3 Mechanical Installation Information .......................................................... 20
5.4 Electrical Installation Information ............................................................. 27
6 COMMISSIONING AND CALIBRATION ......................................................... 31
6.1 Fan Interlock ............................................................................................ 31
6.2 Earth Leakage ......................................................................................... 31
6.3 Earth Fault Lockout .................................................................................. 31
6.4 Earth Continuity ....................................................................................... 31
6.5 Insulation test .......................................................................................... 31
6.6 Over Current / Motor Overload Current Injection ...................................... 31
6.7 Short Circuit Current Injection .................................................................. 32
6.8 Current Detection in CTs ......................................................................... 32
6.9 Main Contactor Fail .................................................................................. 32
6.10 Voltage Measurement ............................................................................ 32
6.11 RDM ...................................................................................................... 32
6.12 PLC Interface ......................................................................................... 32
6.13 RTU ....................................................................................................... 32
6.14 Start, MCI and Stop Inputs ..................................................................... 32
7 REMOTE DISPLAY MODULE (RDM-D) .......................................................... 33