Ampcontrol Pty Ltd – ABN 28 000 915 542
IPD USER MANUAL
IPDB014 Version 14 – SEP/2020
Uncontrolled Copy - Refer to Ampcontrol Website for Latest Version
APPROVED FOR EXTERNAL DISTRIBUTION
– PROPERTY OF AMPCONTROL PTY LTD
– NOT TO BE REPRODUCED IN PART
2.2 Operational Restrictions and Limits
The operational restrictions listed below must be understood before considering using the IPD within
systems designed to ensure the safety of personnel.
2.2.1 Installation
The selection, installation, commissioning and use of this protective
device should only be undertaken following the application of a detailed
risk assessment that is consistent with the methodology outlined in
AS/NZS ISO 31000 risk management. Additionally, identified risk
control measures identified within the risk assessment additional to
safety controls and/or directions contained within the products operating
manual must be validated as effective before use of the product in any
capacity.
The IPD integrated protection relay is NOT designed to be used as
the sole means of ensuring safety to personnel or equipment.
The IPD integrated protection relay is NOT water resistant and must
be mounted within a suitably IP rated enclosure for use where the
overall system is to be rated water resistant
To comply with the Conditions of Certification, ensure full serviceable
life of the product, and avoid nullifying the warranty, it is essential to
exercise great care with the installation, use and storage of the System
components. Failure to comply with the Conditions of Certification may
seriously compromise the integrity of the system and/or its
components, and the consequence could be fatal. The user must
ensure that the “Conditions of Safe Use” outlined in the certificate are
met or the certificate (and the IS rating) will not be valid.
The IPD integrated protection relay is NOT certified for use in Group
II hazardous area applications
The IPD integrated protection relay must NOT be modified in any
way. A controller that differs in any way from its ‘as-certified’ condition
must not be used.
To Next Page
Loading...
