Installation Procedures: 17" Panels
68
VG Series Modero Touch Panels
2. Locate the edges of the two studs used in this installation. The location of the NXD is site dependant and could
involve notching more than one beam.
3. Remove any screws/nails from the drywall, along the notched beam, before beginning the cutout process.
4. Cut out the surface for the NXD-1700VG Wall Mount using the dimensions shown in FIG. 58. Be sure to cut out
the four notches along the top and bottom areas to accommodate the four drywall expansion clips (provided).
5. Remove the magnetic faceplate/bezel (A in FIG. 59) from the main NXD unit (B in FIG. 59) by gripping the
faceplate and pulling with gentle outward force.
In this sample installation, the left beam is notched and the back box rests against the
right beam.
FIG. 58 NXD-1700VG Wall Mount panel dimensions using expansion clips
*
*
* Top notches are
not symmetrical
Left Side
Right Side
Connectors
To Next Page
Loading...
