ADV7511W HARDWARE USER’S GUIDE
Rev. A
Page 7
of 45
Rev A
SECTION 1: INTRODUCTION
1.1 Scope and Organization
This document is intended to help the hardware designer understand what is necessary to design for the ADV7511W
and maintain the highest levels of performance. The ADV7511W Hardware User's Guide (HUG) provides guidelines to
design the schematics and board layout. Included are sections on the 64-lead LQFP package and an overview of the
functional blocks (including a brief description for each block) to provide an understanding of the ADV7511W
functional and performance capabilities. The ADV7511 Programming Guide (PG) is available as a separate document
and should be used to gain a complete understanding on how to configure the ADV7511W within a system
application.
It is divided into the following sections:
Section 2
: Reference Documents is a list of other references, which will be helpful when designing with the
ADV7511W HDMI Transmitter.
Section 3
: Block Diagram gives an overall functional view of the HDMI transmitter.
Section 4
:Specifications give all pertinent data such as: timing, power and testing.
Section 5:
Pin and Package Information give the mechanical details of the interface.
Section 6:
Functional Description serves to elaborate on input, output and internal operations.
Section 7
: PCB Layout Recommendations are an aid to low noise operation.
1.1.1
Links
There are many links in this document to help with navigation. Use a mouse click to follow a link, and use the Alt key +
left arrow key to return. Active links can be identified by the dotted blue underline.
1.1.2
Symbols
Symbols are used to indicate internal and external document references as follows:
▶ Indicates a linked reference to another section of this document.
▷ Indicates a reference to another document, either an ADI document or an external specification.
1.1.3
Format Standards
In this document, ADI has chosen to represent data in the following ways:
0xNN Hexadecimal (base-16) numbers are represented using the “C” language notation, preceded by
0x.
0bNN Binary (base-2) numbers are represented using “C” language notation, preceded by
0b.
NN Decimal (base-10) numbers are represented using no additional prefixes or suffixes.
Bit Bits are numbered in little-endian format; i.e., the least-significant bit of a byte or word is referred to
as bit 0.
To Next Page
Loading...
Need help?
General