System Operation
Andover Controls Corporation 6-15
TOC
Printing or Modifying with Infinet Controllers
If you want to print, modify, enable or disable an Infinet controller point,
you must tell the system the path name to the Infinet controller. There
are two different methods for doing this. The first method is to type in
the path name then the point name direcly in the CX9200 Command
window.
For example:
R>
Print AHU2 Sfan
INFINITY1 AHU2 Sfan = On
R>
FLR3TCX DefaultDmprPosn = OFF
R>
Disable AHU1 AHU_Control
The other method is to Connect to the Infinet controller. Once
connected to the Infinet controller, all commands entered through the
Command window are now directed towards the Infinet controller.
You connect to the Infinet Controller by selecting CONNECT from the
Main Menu Bar. The system will then prompt you for the controller
name that you wish to connect to. Once connected, the current path will
be displayed at the top of the Command window.
Saving and Loading
You can save and load any objects in the system. You will need a
computer connected to the user port that is running a communications
package that will capture the data coming from the CX9200, as well as
load it back.
For example, if you wanted to save all of the files and points in your
system you would type the following in the CX9200 Command window:
R>
Save Site
The system would then prompt you to hit any key when ready. At this
point you should set up your computer to capture the data into a file,
then hit any key. The Infinity system will then transmit all of the
programs, files, and other information that is contained in all of the
controllers in the system.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
