Andover Controls Infinity User Manual

Configuring the System
Andover Controls Corporation 4-5
TOC
Using the Menus
Although many of the Infinity Menus look different, they all respond to
the same set of keystrokes. This section summarizes some of these
keystrokes.
You change between the Main Menu Bar selections using the LEFT and
RIGHT ARROW keys. In order to accept a selection, you can either
press ENTER while the selection is highlighted, or enter the first letter
of the selection.
You change between selections in a pulldown menu using the UP and
DOWN ARROW keys. In order to accept a selection, you can either
press ENTER while the selection is highlighted, or enter the first letter
of the selection.
Once in another menu, you use the TAB key to change from attribute to
attribute. To go to the previous attribute, hit the ESC key, then the TAB
key.
If an attribute uses a small window and has a list of selections that have
a set of parentheses before them, use the UP and DOWN ARROWS to
change between the selections, and use the SPACE bar to accept a
selection. After you accept the selection, an X will appear in the
parentheses.
When the system is prompting you to enter a name, you can press the F2
key to get a list of the available choices.
The F4 key allows you to toggle between the Menu Bars and the
Windows.
Logging Off the CX9200
In order to Log Off the CX9200, simply select the Logout selection from
the Main Menu Bar.
After Logging Off the CX9200, it will not respond to anything you type
on the terminal. You must perform the Logging On procedure if you
want to communicate with the CX9200 again.
Technical Manuals Online! - http://www.tech-man.com

Andover Controls Infinity Specifications

General

Brand	Andover Controls
Model	Infinity
Category	Controller
Language	English