Andover Controls Infinity User Manual

Configuring the System
4-18 Infinity Smoke Control Guide
TOC
Creating and Editing Files
This section briefly explains how to create and edit a File. A File can be
a Program, a Function, a Data file or a Report. These Programs, which
run in the CX9200 and in the Infinet controllers, determine how the
Infinity smoke control system operates.
The Programs are written in Andover Controls’ Plain-English language.
It is beyond the scope of this manual to explain the Plain-English
language or how to write Programs. Refer to the following Andover
Controls documentation for Plain-English programming instructions:
Plain English Language Reference
(P/N 30-3001-165)
Infinity CX Programmer’s Guide (P/N 30-3001-166)
Creating a Program
Select Edit Files from the Main Menu Bar. If the Program will be
running in an Infinet controller, enter the name of the Infinet controller
at the InfinetCtlr prompt. If the Program will be running in the CX9200,
leave the InfinetCtlr prompt blank. Enter the name of the Program at the
Name prompt. If it is a new Program, you will have to type in the name
that you wish to give the Program, such as:
SmokeSelfTest
FSCS_Interface
If you are editing an existing Program, you can hit the F2 key at the
Name prompt and get a list of the available choices.
After entering the Program Name, the File window will appear. The File
window allows you to enter a Description for the Program or define the
attributes of the Program, such as State, Flowtype or whether or not the
Program should start automatically.
Figure 4-12 shows the File window.
Technical Manuals Online! - http://www.tech-man.com

Andover Controls Infinity Specifications

General

Brand	Andover Controls
Model	Infinity
Category	Controller
Language	English