Andover Controls Infinity User Manual

Installation and Layout
Andover Controls Corporation 3-9
TOC
Field Wiring Terminals
The following are the only field connections that are required when
installing an FSCS. All field wiring must be installed by qualified
personnel and must comply with the National Electric Code, as well as
any state or local regulations.
AC Power Wiring
The AC input voltage is connected to the AC POWER FIELD WIRING
TERMINALS.
Figure 3-4 shows this terminal block and how it is wired.
Figure 3-4. AC Power Terminal Block
RS-232 Communication Port Wiring
The RS-232 cable from the CX9200 connects to the FSCS at the RS-232
FIELD WIRING TERMINALS. This cable must be less than 20 feet in
length, and must be enclosed in conduit.
Figure 3-5 shows this terminal block and how it is wired to the CX9200.
H
N
G
The HOT Terminal (Black wire)
The NEUTRAL Terminal (White wire)
The GROUND Terminal (Green wire)
Technical Manuals Online! - http://www.tech-man.com

Andover Controls Infinity Specifications

General

Brand	Andover Controls
Model	Infinity
Category	Controller
Language	English