Infinity Smoke Control System Components
Andover Controls Corporation 2-15
TOC
Design Guidelines
In order to have the FSCS built to your specifications, you will need to
supply the following:
• An accurate drawing of the smoke control system. This drawing will
be used to create the FSCS front panel graphic.
• A second copy of the FSCS drawing indicating the colors of the
status indicators.
• A third copy of the FSCS drawing indicating the colors that are to be
used for the front panel graphic. Consult Automation Displays, Inc.
for a list of options.
• Specify whether you need a flush-mount or a surface-mount panel.
• Specify whether or not you need a transparent cover for the FSCS.
• Specify whether or not you need a terminal block wired to the FSCS
inputs, to be used for Zoned Wiring to the Fire Panel.
Automation Displays, Inc. will provide you with a copy of the FSCS
drawing that indicates the I/O numbers that correspond to each LED
output and each switch input on the FSCS. Each 2 position switch
requires 1 input and each 3 position switch requires 2 inputs.
The FSCS you order from Automation Displays Inc. will contain the
following:
• An Automation displays’ Autoface IV graphic door with a keylock.
• Switches and Status Indicators for each piece of smoke control
equipment.
• A “Master” keyswitch, a “Clear Faults” push-button, a “Lamp Test”
push-button and a sonalert audible annunciator.
• An Automation Displays’ Q-Card CPU board with the “Andover
Data Interface” firmware that is wired to an RS232 Protection PCB.
• An Automation Displays’ 80 Point Driver card for every 80 status
indicators.
• An Automation Displays’ 80 Point Driver card for reading the FSCS
switches. A 2 position switch requires 1 input and a 3 position switch
requires 2 inputs. A Switch Protection PCB is also included.
• A 5V DC power supply for the Q-Card, the 80 Point Driver cards,
and the FSCS Status Indicators.
Refer to Chapter 5 for a drawing of an example FSCS graphic.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
