Medium-consistency pump MC
STANDARD, C-01-000000
Rev. 0, 2010.02.09 SAFETY Kap.2 , Seite 1 of 20
GRZ-2698567-v1-Safety.FM
2SAFETY
2.1 General safety regulations
The chapter on safety contains general safety regulations which must be
observed when working on the machine/plant.
In addition to the present safety regulations, the various chapters of the
operating manual contain further safety regulations relating to individual
tasks. DANGER and WARNING SIGNS highlight these additional safety
regulations in the operating instructions.
Safety instructions on components not supplied by ANDRITZ AG are
contained in the descriptions of these individual components (
/MEDIUM CONSISTENCY PUMP MC/ SUPPLIER DOCUMENTATION).
The safety instructions supplement ANDRITZ AG's operating instructions.
All safety instructions must be observed. Disregarding the safety
instructions may cause a risk to life and limb, environmental pollution
hazards and/or damage to property.
2.2 Danger and warning signs
The entire SAFETY chapter is of extreme importance and relevant to
safety. Thus, the information in this chapter is not marked with special
danger and warning symbols.
In the Chapters on ERECTION WORK, START-UP, OPERATION, and
MAINTENANCE in this Manual, warnings are marked by a pictogram. The
following warning signs are used:
DANGER
This symbol indicates there may be a risk to life and limb.
Non-compliance with the warning signs may lead to serious health
problems or even fatal injuries, and can cause extensive damage to
property.
WARNING
This symbol indicates that there is an imminent health risk, as well
as a risk of environmental pollution and of damage to property.
Non-compliance with the warning signs may cause moderate health
problems and/or extensive environmental pollution and damage to
property.
CAUTION
This symbol gives warning of a dangerous situation.
Non-observance of these signs may cause environmental pollution and
damage to property.
To Next Page
Loading...
