number using the Up/Down Arrow key and press the
ENTER key to implement. Setup 0 recalls the fac-
tory preset state.
RUN
HOLD
When in the Hold mode, this key starts the Site Mas-
ter sweeping and provides a Single Sweep Mode
trigger; when in the Run mode, it pauses the sweep.
When in the Hold mode, the hold symbol (Table 2-1,
page 2-54) appears on the left side of the LCD.
(HOLD conserves considerable battery power.)
SAVE
DISPLAY
Saves the displayed trace to 1 of 70 internal
non-volatile memory locations. When the key is
pressed, the next available empty memory location
appears on the display (i.e.“Save display 3”). Press
ENTER to save to the current empty memory loca-
tion or select an appropriate number from the key-
board or use the Up/Down Arrow key and press the
ENTER key to implement.
To erase saved displays select 0 and press ENTER.
Individual displays may be selected and erased by en-
tering the display number and pressing ENTER. Se-
lecting display 0 will erase all saved displays.
CAUTION:The selected memory location will be over-
written by the SAVE DISPLAY operation. No warning
is given.
When the
Site Master
is cycled on/off, the memory
location increment resets to the lowest memory loca-
tion (1).
SAVE
SETUP
Saves the current system setup to 1 of 6 internal
non-volatile memory locations. When the key is
pressed, “Save Setup:” appears on the display. Select
an appropriate number using the Up/Down Arrow
key and press the ENTER key to implement.
2-3
Chapter 2 Operation
To Next Page
Loading...
