q
Connect LOAD, Press ENTER
The Site Master will measure the 50W termina-
tion (load) that you must attach to the end of the
test port.
NOTE:
The combined measurements of an open, a short,
and a known-impedance load in coax calibration and
of known-offset shorts and known-impedance load in
waveguide calibration normalizes the measurement
system, to account for uncertainties introduced by
measurement-system components (e.g., cables, con-
nectors, etc.).
Up/Down
Arrow Key
Increments or decrements a parameter value.
NOTE:
At turn on, before any other keys are pressed, the
Up/Down Arrow Key may be used to adjust display
contrast.
2-5
Chapter 2 Operation
To Next Page
Loading...
