Anyview A8 - Page 87

Patient monitor User’s manual
Chapter 7-14
7.7.3 Setting Arrhythmia Alarm
Select
【
ARR Analysis
】
→
【
ARR Alm Setup
】
in the ECG setting menu,
in the popped up menu, you can set the alarm status for each Arrhythmia,
including alarm switch, alarm level and alarm print switch. You can select
【
ALL ARR Alm-Resume Default
】
,
【
All ARR Alm-Alm Switch
】
,
【
ALL
ARR Alm-Alm Level】and【All ARR Alm-Alm Print】to set the alarm status
for all arrhythmia.
Arrhythmia can be analyzed by the monitor is shown in the following table:
Arrhythmia Type
Applicable Patient
Type
Alarm Level
ASYSTOLE
All
Default High
VENT FIB/TACH
Non-paced
Default High
PAC
Non-paced
Default medium,User selectable
RUN PVCS
Non-paced
Default medium,User selectable
COUPLET
Non-paced
Default low,User selectable
BIGEMINY
Non-paced
Default low,User selectable
TRIGEMINY
Non-paced
Default low,User selectable
R ON T
Non-paced
Default low,User selectable
TACHY
All
Default medium,User selectable
BRADY
All
Default medium,User selectable
MISSED BEATS
Non-paced
Default low,User selectable
PNP
Paced
Default medium,User selectable
PNC
Paced
Default medium,User selectable
NOISE
All
Default low,User selectable
VPB
Non-paced
Default low,User selectable
ST HIGH
All
Default low,User selectable
ST LOW
All
Default low,User selectable
VTACH
Non-paced
Default High
PVCS HIGH
Non-paced
Default low,User selectable
7.7.4 Arrhythmia Relearning