ANZ POS MOVE - Terminal Battery and SIM Card; Battery Charging Procedures; SIM Card Information

25
10.7 BATTERY
When does the battery need to be charged?
• On initial start-up, it is important to charge the battery for until it is fully charged
• Before commencing a shift, make sure the battery is completely charged to ensure
the maximum number of transaction can be completed
• When used daily, the terminal recharges its battery each time it is placed on its base
and is connected to the main power outlet on the wall.
10.8 HOW THE BATTERY CAN BE CHARGED
10.8.1 Using the base
• Place the terminal on its base
• Check if the battery symbol has a small lightning bolt above it (=battery charging).
10.8.2 Using the MicroUSB charger
• The USB connector on ANZ POS MOVE terminal is located on the left hand side.
• Insert the Micro USB cable into the USB socket on the terminal.
• Connect the USB connector into the computer’s USB port.
10.8.3 Using the terminal power supply (the terminal is o the base)
• Connect the terminal power supply unit to the terminal connector located on the left
side of the terminal.
• Connect the power supply unit to the power supply mains network.
• Check if the battery symbol has a small lightning bolt above it (=battery charging).
10.8.4 Power jack directly to the terminal
• Connect power supply unit to the dedicated power jack on the left side of the
terminal.
• Connect the power supply unit to the power supply mains network.
• Check if the battery symbol has a small lightning bolt above it (=battery charging)
10.9 SIM CARD
A SIM Card is provided with your ANZ POS Move terminal. If your SIM Card cannot be
read or has not been inserted the terminal will display ‘No SIM’