ARAG VISIO BLC - Options; Language; Unit of Measurement; Display Contrast

21
SETTING
- Access the selected menu
- Confirm changes and go back to previous menu
- Go back to previous menu
- Quit without confirming the changes
Pressed in sequence:
- Scroll the pages of a menu
- Change a value (increase)
Move the cursor during a change (press a
few times)
PROGRAMMING KEYSPROGRAMMING KEYS
12.2 Options
Fig. 44
Setup menu
BLC settings
Options
...
Setup management
1
Options
Language
English
Unit of measurement
Display contrast
2
1
Access the Setup menu > Options.
2 Press OK to edit the selected menu
item.
The display will show the current setting
below the selected item.
Use of the keys at the bottom of the page.
12.2.1 Language
Fig. 45
Language
Español
Français
Magyar
English
Access the Options > Language menu.
Set the desired language.
12.2.2 Unit of measurement
Fig. 46
Unit of measurement
Speed
m/s
Length
Height
Access the Options > Unit of measurement menu.
Set unit of measurement for the values detected by the device:
Speed, Length, Height, Angle.
12.2.3 Display contrast
Fig. 47
Display contrast
50%
Access the Options > Display contrast menu.
Set display contrast:
Increase by 5%.
Decrease by 5%.
12.2.4 Alarm tones
Fig. 48
Alarm tones
OFF
ON
Access the Options > Alarm tones menu.
Enable/disable the alarm tones.
12.2.5 Keytones
Fig. 49
Keytones
OFF
ON
Access the Options > Keytones menu.
Enable/disable keytones.