Areca ARC-1280ML - For Linux

ARCHTTP PROXY SERVER INSTALLATION
110
5.2 For Linux
You must have administrative level permissions to install SATA
RAID software. This procedure assumes that the SATA RAID hard-
ware and Linux are installed and operational in your system.
The following details the Linux installation procedure of the SATA
RAID controller software.
1. Insert the SATA RAID controller CD in the CD-ROM drive.
2. Copy <CD-ROM>\PACKAGES\Linux\http directory to local
(Ex:/usr/local/sbin)
3. Setting up the "archttpsrv.conf" of ArcHttp conguration. For
example: Http Section, Mail Section, EvtLevel, etc. Please refer to
"main.conf". (We recommend you use remote mail congura-
tion).
Usage: ./archttp32 (TCP_PORT) or ./archttp64 (TCP_PORT). It
depends on your OS version.
Parameters: TCP_PORT value= 1~65535 (If TCP_PORT assigned,
Archttp will start from this port. Otherwise, it will use the setting
in archttpsrv.conf )
4. Runing the ArcHttp le then ArcHttp screen appears.
Copyright (c) 2004 Areca, Inc. All Rights Reserved.
Areca HTTP proxy server V1.6 for Areca RAID controllers.
Controller(s) list
--------------------------------------------
Controller[1](PCI) : Listen to port[81].
Mail Cfg Assistant : Listen to port[83].
--------------------------------------------
##############################
Press CTRL-C to exit program!!
##############################
3. See the next chapter detailing the McRAID Storage Manager to
customize your RAID volume set.