DRIVER INSTALLATION
99
4. Driver Installation
This chapter describes how to install the SATA RAID controller driver to
your operating system. The installation procedures use the following
terminology:
Installing operating system on the SATA Volume
If you have a new drive conguration without an operating system
and want to install operating system on a disk drive managed by the
SATA RAID Controller. The driver installation is a part of the operat-
ing system installation.
Installing SATA RAID controller into an existing operating
system
The computer has an existing operating system installed and the
SATA RAID controller is being installed as a secondary controller.
Have all required system hardware and software components on
hand before proceeding with the setup and installation.
Materials required:
• Microsoft Windows 2000/XP/2003, or Linux, or FreeBSD installation
CD-ROM
• SATA RAID Controller Diver CD-ROM
• SATA RAID controller
4.1 Creating the Driver Diskettes
The CD-ROM disc shipped with the SATA RAID controller is a self-
booting CD. In order to created driver diskettes for Windows,
Linux, and FreeBSD installation drivers, your system is required to
support booting from the CD-ROM.
If you do not have the CD-ROM disc with the package, contact your
local dealer or you can also download the latest version drivers for
Windows 2000/XP/2003, Linux, and freeBSD from the ARECA web
site at http://www.areca.com.tw
The following steps are required to create the Driver diskettes:
To Next Page
Loading...
