P/N PM000223A • Rev. 1 • ISS 9 August 2017 49
Installation Manual
NU-Series Hardware
IP Devices
Mounting a Single Display on a Bracket
Use the mounting accessories for a single display that are included with the wall mounting
bracket.
To mount single display to the wall mounting bracket:
1. Ensure that the LAN cable is connected to the corridor display. See "5.4.5, Connecting
the LAN Cable" on page 43.
2. Remove the two hex screws at the top of the display using a hex key.
3. Use the included accessories to mount the display on the bracket, as shown in the
figure below.
Figure 40 Mount the display on the bracket
To Next Page
Loading...
