36
Note:
• The projector does not support images
with resolution higher than 1920*1200. If the
resolution of your PC screen is so, please re-
set to lower before connecting to the projector.
• Image data other than XGA (1024 x 768) will
be modified to those applicable to the screen
size in the initial mode.
• If no signal is detected in the PC system
menu, options of True, Full, Digital zoom +
and Advanced are not available.
Computer input
Digital zoom +
After you select the digital zoom +, the on-
screen menu will disappear, while the
information on digital zoom + appears. You can
press Select to zoom in the image size, and
press ▲▼◄►to move the image horizontally
and vertically.
The moving is effective only when the image is
larger than the size of the screen.
You can also press D.zoom +or select on the
remote control to zoom in the projected image.
Digital zoom -
After you select the digital zoom -, the
on-screen men will disappear, while the
information on digital zoom - appears. You
can press Select to zoom out the imag size.
You can also press D.zoom - or select on
the remote control to zoom out the projected
image.
To exit the “digital zoom +/-“mode, press
any button except the D.ZOOM+/- and the
OK button. To return to Normal size, select “
Screen” in the menu to adjust screen size, or
enter a new input source in the menu “Input”.
Or use keys▲▼ for digital zoom to adjust the
screen size.
Advanced
This function is used to set the horizontal/
vertical position and quantities of the projector
in image segment and mosaics.
Press OK button at Advanced, Advanced menu
appears on the screen. Press ▲▼ button
toselect and adjust your required item.
H total: set the total quantities of the projector
at horizontal direction. Image will be
segmented by vertical direction. setting value
from 1 to 512.(WXGA mode:1-640)
V total: set the total quantities of the projector
at vertical direction. Image will besegmented
by horizontal direction.setting value from 1 to
384.(WXGA mode: 1-400)
Position H: set the horizontal position of the
projector. Setting range: from 1 to the total
quantitiy of projectors at horizontal direction.
Position V: set the vertical position of the
projector. Setting range: from 1 to the total
quantitiy of projectors at vertical direction.
Note:
"Advanced" is enable only for VGA1 input.
To Next Page
Loading...
