You can setting the advanced functions below by the "Advanced setting" menu of the projector.
1 Press MENU button to display the screen
menu. Press
button to select Advanced
setting icon and then press
or OK
button.
2 Press
to select the desired item to be
adjusted, and then press
or OK enter
the item.
3 Press
to select the item, press
button to adjust.
Set the language used in screen menu.
Language
Menu position
You can use this function to change the
position of screen menu.
Press
select Menu position and press
or OK to enter the menu position.
Press
to switch the items: Upper left,
Upper right, Center, Lower left, Lower right.
Auto setup
Allows you to perform input search, auto PC
adj, and auto focus, press the AUTOSET
button on the side control or remote control.
The functions can be switched based on the
steps below.
Input search
Allows you to automatically detect input
signals. It stops when a signal is found.
Press to select an option from:
Off........Disabled.
On........Enabled. This function is used to
detect input signals automatically
and stops when nding a signal.
Auto PC adj
On........Press the AUTOSET button on the
top control or remote control to
enable Auto PC adj function
automatically.
Off........Disable.
Auto focus
On........Press the AUTOSET button on the
top control or remote control to
enable Auto focus function
automatically.
Off........Disable.
Note:
• Only the last selected input source can be detected.
• If the INPUT button on the top control or on the remote
control is pressed during Input search is in progress,
Input search will stop and go back to the previous
input signal.
• Input Search, Auto PC Adj. cannot be set Off at the same
time.
• Fine sync., Total dots, Horizontal and Vertical position
of some computers cannot be fully adjusted with the
Auto PC Adjustment function. When the image is not
provided properly with this operation, manual adjustments
are required.
To Next Page
Loading...
