Ask Proxima E2465 - Page 45

45
Advanced setting
Logo (Logo and Logo PIN code lock settings)
This function allows you to customize the screen logo with Logo select, Logo PIN code lock and
Logo PIN code change functions.
Logo select
This function decides on the starting-up display from among following options.
Default .... Show the factory-set logo.
Off ........... Show the countdown display only.
Logo PIN code lock
This function prevents an unauthorized person from changing the screen logo.
Off ...... .....The screen logo can be changed freely from the Logo Menu.
On ...... .....The screen logo cannot be changed without a Logo PIN code.
If you want to change the Logo PIN code lock setting, press the SELECT button and the Logo PIN
code dialog box appears. Enter a Logo PIN code by following the steps below.
Keystone
This function is used to store or reset the keystone correction when the AC power cord is
unplugged. Press

to select the itmes below:
Keystone:
Store..................Store the keystone correction even when the AC power cord is unplugged.
Reset ................Reset the keystone correction when the AC powercord is unplugged.
H/V Keystone ..Press

to correct keystone distortion in horizontal and virtical position.
Corner............... Press CORNER and

buttons on remote control to correct corner
keystone distortion.Correcting order is as followings:
upper-left→ upper-right → lower-right → lower-left→...
Press

to correct the upper-left corner keystone distortion.
Press

to correct the upper-right corner keystone distortion.
Press

to correct the lower-right corner keystone distortion.
Press

to correct the lower-left corner keystone distortion.
Logo PIN code lock
Use the Point ▲▼ buttons to enter a number. Press the Point ► button to x the number and move the
red frame pointer to the next box. The number changes to “*”. If you xed an incorrect number, use the
Point ◄ button to move the pointer to the number you want to correct, and then enter the correct number.
Repeat this step to complete entering a three-digit number.
After entering the three-digit number, move the pointer to Set. Press the SELECT button so that you can
start to operate the projector.
If you entered an incorrect Logo PIN code, Logo PIN code and the number (***) will turn red for a
moment. Enter the correct Logo PIN code all over again.
Change the Logo PIN code lock setting
Use the Point ▲▼ buttons to switch No or Yes , and then press the SELECT button to make a choice.