23
GENERAL
Remote Control And Signal
Output
The following input and output signals are provided
through two 9 pin D type connectors;
1. Remote control : Test, Reset, and Remote Interlock.
2. Remote recall of memory program #1, #2 and #3
3. Outputs : Pass, Fail, Test-in-Process, and Reset
Program Memory 10 Memories, 3 steps per memory, all steps within a
memory are linkable.
Security Key Lock capability to avoid unauthorized access to all
test parameters. Memory Lock capability to avoid
unauthorized access to memory locations.
Safety Built-in Smart GFI circuit
Display 128 x 64 dot resolution with front panel contrast setting.
Alarm Volume Setting Front panel adjustable volume setting with 10 set points.
Line Cord Detachable 7 ft. (2.13m) power cable terminated in a three
prong grounding plug.
Terminations Detachable 5ft.(1.52m) high voltage and return leads (2)
with clips and a standard U.S. style (NEMA 5-15) remote
receptacle
box for testing items terminated with a line cord.
International receptacles also available. Front and Rear
outputs standard.
Mechanical Tilt up front feet.
Dimensions: (W x H x D) (215 x 89 x 370 mm)
Weight: 20.96 lbs. (9.53Kgs)
Environmental
Operating Temperature : (0° - 40°C)
Relative Humidity - 0 to 80%
Calibration Traceable to National Institute of Standards and
Technology (NIST). Calibration controlled by software.
Adjustments are made through front panel keypad in a
restricted access calibration mode. Calibration information
stored in non-volatile memory.
To Next Page
Loading...
