37
4.2.2. Editing Test Parameters (Refer to FIG.2)
1. From the Test parameter review screen (refer to section 4.2.1), scroll the cursor to the test
parameter you wish to edit using the up and down arrow soft keys.
2. Press the Edit soft key. The Test parameter edit screen will now be displayed.
3. You may now change the value of the test parameter with the up and down arrow soft keys.
4. Press the Enter soft key to accept the new value or press Esc to escape from the edit.
All available test parameters may be edited using this procedure.
4.2.3. Reviewing Test Results
Method 1, Hot key
1. Pressing the bottom soft key at the Perform Test screen will display the Results screen.
Method 2, Menu Selection
1. From the Perform Test screen, press the “Menu” soft key. The Main Menu will now be
displayed.
2. From the Main Menu screen, press the “Menu” soft key. The Results, Test and System
selections will now be displayed.
3. From this screen, press the “Result” soft key. The Results screen will now be displayed.
The Results screen will appear as follows:
For connected tests, use the up and down soft keys to scroll through the results.
4.3. Test Parameters
Description of Test Parameters
Voltage: The Voltage that is applied to the High Voltage and Return terminals or the Current
and Return terminals during a test.
Max Lmt: A maximum current or resistance threshold that when exceeded triggers a failure.
Max-Fail
^
Settings Results
v
25.00A ––.––A
0m
Ω
0.0s
1.0s
To Next Page
Loading...
Need help?
General
