35
Warning screen every time you power up the instrument. The question must be answered by
toggling between the word “Yes “and “No” using its corresponding softkey and then pressing
the OK softkey. You may turn this screen “OFF” by toggling to the word “No” using the soft
key next to this parameter and pressing the OK soft key. Selecting the “Show this screen
again” parameter “No” will disable the Calibration Alert function. You may leave this screen
“ON” by toggling to the word “Yes” using the soft key next to this parameter and the pressing
the OK soft key. Selecting the “Show this screen again” parameter “Yes” will exit the
Calibration Alert Warning screen and go to the standard introduction screen without disabling
the Calibration Alert function.
If security is enabled you will not see the question “Show screen again” or the Yes/No soft
key.
It is possible to quickly bypass the security of the Calibration Alert by powering up the
instrument while depressing the soft key that is second from the top of the instrument. This
will temporarily start the instrument in an unsecured state. The Calibration Alert Warning
screen will be displayed and allow you to disable the Calibration alert by selecting “No” and
then pressing the OK soft key. This type of security override only affects the Calibration alert
screen. It is not necessary to restart the instrument to activate the security setting.
To Next Page
Loading...
