4. Navigate to the Advanced BIOS Features, and set the following configurations:
a. First Boot Device to the CD-ROM option
b. Second Boot Device to the hard disk option
c. Third Boot Device to the LAN option
5. Navigate to Integrated Peripherals.
6. Select Onboard Device, and set the following configurations:
a. USB Keyboard Support to Enabled
b. Onboard Lan Boot ROM to Enabled
7. Select OnChip IDE Device, and set the following configurations:
a. On-Chip Serial ATA to Enhanced Mode
b. SATA PORT Speed Settings to Force GEN I
8. Select Super IO Device, and set PWERON After PWR-Fail to On.
9. Navigate to the Main tab, and select Save and Exit Setup.
4.3 BIOS Q35AX American Megatrends
To configure BIOS version Q35AX American Megatrends, follow these steps:
1. Reboot the development workstation, and immediately press the Delete key as the system
boots to enter the BIOS Setup Utility.
2. Navigate to the Exit tab, and select Load Optimal Defaults.
3. Navigate to the Main tab, and set the date and time using Greenwich Mean Time.
4. Navigate to Advanced > CPU Configuration, and set the following configurations:
a. Intel® SpeedStep™ tech to Disabled
5. Navigate to Advanced > IDE Configuration, and set the following configurations:
a. SATA#1 Configuration to Enhanced
b. Configure SATA#1 to IDE
6. Navigate to Advanced > SuperIO Configuration, and set the following configurations:
a. Serial Port 1 Address to Disabled
b. Serial Port 2 Address to Disabled
8 Copyright © 2018 Advanced Simulation Technology inc.
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...